Littlest Pet Shop Problems

Alcuni consigli e trucchi per la casa

Tips for Home

How to stop the moisture on the walls

Needed:

foil type Domopak

upholsterer glue (available at any hardware store)

stucco walls



paint walls a soft bristle brush

a spatula to smooth stucco

120 grit sandpaper

Procedure:

Clean surface with a sponge or rag.

Prepare the glue upholsterer (usually powders) are mixed with water in a bowl, stirring well until mixture is thick and smooth.


Cut the foil to a size slightly above the surface to be careful not bucarla or wrinkled.


Dip the brush in the glue from upholstery and brush in piu 'replied the surface.

Apply the foil to the smooth wall con una spatola di plastica o lisciandola con il palmo dellla mano,facendo sempre attenzione a non bucarla o stropicciarla (volendo ottenere un miglior risultato applicare piu' strati di stagnola).


Spennellare succesivamente, intingendo il pennello nella colla, la superficie della stagnola appena applicata per permettere una maggiore aderenza.


Dopo un adeguato tempo di asciugatura (diverse ore) applicare, possibilmente con una spatola di plastica, lo stucco per muri in piu' riprese (con un adeguato tempo di asciugatura fra una ripresa e un altra), lisciando la superficie da trattare,tirando lo stucco con tatto e in un unico verso di stesura onde evitare bolle di rigonfiamento o strappi della paper. For

total putty dry sandpaper the surface with fine grain sandpaper to smooth any imperfections.

-painted the area treated.



Waterproof balconies and terraces


Needed:

tile filler powder (usually in 5kg bags available from any supplier of building materials)
transparent waterproofing primer (specific product for waterproofing, a little more difficult to find, however, just turn a bit and you can still find it). One possible
rag, lint.
A sponge.
A trowel (purchased at any building supplier). A bucket
mason (purchased at any building supplier).
A soft plastic spatula or a frataxin mason for grouting tile (purchased at any building supplier).


Method: Wash thoroughly

the surface to be treated better if we use highly degreasing products.

the floor dry completely and proceed as follows:
different parts of the content of the grout in tile dust in the bucket, versiamoci water and begin to mix with the trowel it all, until you reach un'impasto creamy and homogeneous. We take our

frataxin or plastic spatula and begin to apply the product on the floor, pulling right up to completely fill all the gaps between tiles, do the same job on any slate or marble threshold of the terrace, with particular attention to holes for sets of rails (especially susceptible to leakage). We pull the grout well

helping with frataxin, trying not to leave ridges then difficult to remove.

try to be fast and above all do not worry too much about how dirty the floor.

As soon as we see the grout to begin to darken, and then to dry, we reverse the contents of the grout powder remaining on pavimento.Distribuiamolo with a soft broom or by hand evenly over the terrace and started to scrub with a sponge the whole.

You will notice that the grout powder will tend to clean the tile and at the same time to further fill the gaps. Once the floor is cleaned and filled the gaps let rest at least twenty four hours.

dry floor, pour the product on the floor and waterproofing stendiamolo with the rag until you obtain a smooth and glossy surface (a bit like making the wax).

repeat this step after a few hours and then the floor whenever it needs it (at least every six months).

Good luck to all

Adapted from www.micheledile.altervista.org